Honda Crosstour Forums banner
1 - 3 of 3 Posts

·
Premium Member
Joined
·
443 Posts
Discussion Starter · #1 ·
I'm considering using a set of 5-spoke wheels that I have with a 40mm positive offset to mount some 245 wheels but I can't find data on the center bore size on the OEM wheel. If someone knows it off-hand I'd appreciate having that information. If not, I'll pull the wheel and take measurements.
 

·
Premium Member
Joined
·
443 Posts
Discussion Starter · #3 ·
Thanks ever so much for your response.

I have a pair of aluminum centric rings that I can use to move the wheel bore from 70.1 down to 64.1. I got lucky on that one.

Now all I have to do is to figure out how to recalibrate the speedo with my SpeedoHealer to compensate for the low-prifile tires. I've been searching through the service manual in an effort to find the VSS signal and where to interrupt it to install the SpeedoHealer without success. Guess I'll need to get the Electrical Troubleshooting Manual to find what I want.

Once again. Thank you.
 
1 - 3 of 3 Posts
Top