Honda Crosstour Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
have new pads all round it’s a noise on the drivers side front wheel making noise what I think it is a hub bearing but not sure if I need to replace the front Axle if anyone noticed all the lights come on at the same time but I turn the car off and start it again lights go away and then later down the road it comes back on Thanks for your help 🙏
 

·
Registered
Joined
·
2 Posts
have new pads all round it’s a noise on the drivers side front wheel making noise what I think it is a hub bearing but not sure if I need to replace the front Axle if anyone noticed all the lights come on at the same time but I turn the car off and start it again lights go away and then later down the road it comes back on Thanks for your help 🙏
I have same codes cycling on and off with my 2010 Crosstour EX-L. It all started in 2020 after new brake pads were installed. i am thinking a sensor got disconnected?
 

·
Registered
2012 Honda Crosstour
Joined
·
11 Posts
I had the same exact warning lights… here’s what I posted awhile ago when someone else posted about it:
So I have a 2012- EX-L
Same exact problem... had a friend of mine try replacing the wheel sensors.. which needed to be replaced because they were welded in on the front wheels... but of course that did not fix the issue.. he did some further research and found exactly what you said and research says it’s a issue with many Honda’s.... he can fix it but I just checked and I still have the extended warranty.... so I’m taking it in... we will see if they will cover it before I have to come out of pocket.
It was covered… it’s the abs modulator…cost without the warranty would have been $1700
As I was leaving the shop I was parked right next to another crosstour.. 2015…. In for the same exact thing and owner had a 2010 before which also had the same issue.. fixed both and still loves the crosstour
I have had no issues since… that was last year … I would still buy another if they were to make them again…
 
1 - 3 of 3 Posts
Top