Honda Crosstour Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Can anyone post some good photos of the rear molding that goes above the rear gate and right below the roof line?

my rear window shattered and the old molding was removed before I could pay attention to how it was mounted. Thank you!
 

·
Premium Member
Joined
·
405 Posts
The interior upper trim on the tailgate is held in by four plastic clips. You may need to pull the tops of both of the side trim panels to get the upper trim to interface properly. The plastic clips slide into a recess on the back side of the trim. If you do not have the necessary clips, you can get them at your Honda dealer. When you go to the dealer, wear a mask so that they will not see you crying over the price that they charge.

9584
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
L8Apex,
That’s hilarious about the mask. Thanks for the info but I’m looking for how to install a different part.
73225-TP6-A00
Rubber A, Windshield Dam
It’s just a sticker but I need to see where to stick it to and which direction.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #6
Doug,

Thanks for asking. No. Glass installer put the piece where he thought it should go. I’d like to see if he was right. Any help would be appreciated. Thank you!
 
1 - 6 of 6 Posts
Top