FCW, LDW, stability, abs lights came on all of a sudden

Jeff H said:

Did you ever get this issue resolved? I recently had new tires put on and while pulling onto the street all mine came on as well. Have yet to get them to cut off.

Click to expand...

I changed my tires on a 2014 Honda Odyssey Touring elite yesterday. Today I turned on the van to leave and my dashboard has FCW, LDW, VSC lights on. I have an obd2 reader but its no use since there's no check engine light. Any resolution to your issue?

Mrantbanks said:

I changed my tires on a 2014 Honda Odyssey Touring elite yesterday. Today I turned on the van to leave and my dashboard has FCW, LDW, VSC lights on. I have an obd2 reader but its no use since there's no check engine light. Any resolution to your issue?

Click to expand...

Update...I removed the cable from the negative terminal for an hour then put back and started the van.....all warning lghts disappeared and so far haven't come back on.

Mrantbanks said:

Update...I removed the cable from the negative terminal for an hour then put back and started the van.....all warning lghts disappeared and so far haven't come back on.

Click to expand...

Update...1 day later after disconnecting the negative terminal battery cable the lights have returned.. I noticed that the emissions light is now flashing. I took the van in to get the codes read and mechanic said it is registering a misfire on cylinder 2. I am going to replace the spark plugs and replace all ignition coil packs.. my van currently has 92k miles... spark plugs were replaced with NGKs at 60k miles. Will update soon.

Mrantbanks said:

Update...1 day later after disconnecting the negative terminal battery cable the lights have returned.. I noticed that the emissions light is now flashing. I took the van in to get the codes read and mechanic said it is registering a misfire on cylinder 2. I am going to replace the spark plugs and replace all ignition coil packs.. my van currently has 92k miles... spark plugs were replaced with NGKs at 60k miles. Will update soon.

Click to expand...

I had the mechanic re-read the codes and there were two misfires in bank 2 and 5. I had the mechanic swap out all plugs with NGKs and also swapped out all the ignition coils with hitachis. I also replaced the pcv valve. The mechanic cleared all codes and drove a few miles. The van now runs very smoothly and hasn't thrown any codes/warning lights yet. I have driven it only 1 day so far about 60 miles but the warning lights normally would've turned up by now.