Honda Crosstour Forums banner

1 - 13 of 13 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
Sitting in line waiting to get a coffee and the FCW, LDW, stabilility and ABS lights came on... car still ran fine, but would like to get this taken care of. Prefer to do my own work if possible, but know my limitations.. Any suggestions? I've read some of the battery / connection / alternator answers... couldn't really tell if those took care of it or not.. Will appreciate guidance.
 

·
Registered
Joined
·
6 Posts
Discussion Starter #3
Checked battery and alternator,, both are good. Since the check engine light is not on, Autozone couldn't check on codes. I still have, intermittently the light coming on cause by the box assembly sub-relay many have discussed on this forum.
Just in the last few days, I've noticed when I let off the gas, it continues to run about 1,200 rpm,, sort of like a cruise control. So I can let off gas and coast at about 30 mph for quite a distance compared to normal. I think I'm going to have to break down and take to a shop. Seems like some type of electrical issue.
 

·
Registered
Joined
·
1 Posts
Did you ever get this issue resolved? I recently had new tires put on and while pulling onto the street all mine came on as well. Have yet to get them to cut off.
 

·
Registered
Joined
·
3 Posts
Yes but the issue was the ABS wire was broken after the first attempt to install new struts. Replaced the wire and it is working.
 

·
Registered
Joined
·
2 Posts
Yes but the issue was the ABS wire was broken after the first attempt to install new struts. Replaced the wire and it is working.
Damn.. so it still could be almost anything, huh? I’ve seen this issue mentioned a lot but no one really says what the problem was and how it was resolved. When I start my car in the morning, when it’s cold, it works great... no lights come on)... but after driving for about 10 minutes the lights all appear. I don’t understand.
 

·
Registered
Joined
·
4 Posts
Did you ever get this issue resolved? I recently had new tires put on and while pulling onto the street all mine came on as well. Have yet to get them to cut off.
I changed my tires on a 2014 Honda Odyssey Touring elite yesterday. Today I turned on the van to leave and my dashboard has FCW, LDW, VSC lights on. I have an obd2 reader but its no use since there's no check engine light. Any resolution to your issue?
 

·
Registered
Joined
·
4 Posts
I changed my tires on a 2014 Honda Odyssey Touring elite yesterday. Today I turned on the van to leave and my dashboard has FCW, LDW, VSC lights on. I have an obd2 reader but its no use since there's no check engine light. Any resolution to your issue?
Update...I removed the cable from the negative terminal for an hour then put back and started the van.....all warning lghts disappeared and so far haven't come back on.
 

·
Registered
Joined
·
2 Posts
I have a 2014 CT EX-L w/Navi.... just started experiencing the same problem. FCW, LDW, VSA and ABS lights on. Dash display shows "FCW System Failed." I've checked every fuse that I can think of that might be related. I checked my battery with a tester, it tests fine but is about 3 years old. I also have the following DTCs:

66-11
66-13

U0029
U0155
U0416-68

Edit: Backup camera is black (the graphic overlay still appears on it).
 

·
Registered
Joined
·
4 Posts
Update...I removed the cable from the negative terminal for an hour then put back and started the van.....all warning lghts disappeared and so far haven't come back on.
Update...1 day later after disconnecting the negative terminal battery cable the lights have returned.. I noticed that the emissions light is now flashing. I took the van in to get the codes read and mechanic said it is registering a misfire on cylinder 2. I am going to replace the spark plugs and replace all ignition coil packs.. my van currently has 92k miles... spark plugs were replaced with NGKs at 60k miles. Will update soon.
 

·
Registered
Joined
·
4 Posts
Update...1 day later after disconnecting the negative terminal battery cable the lights have returned.. I noticed that the emissions light is now flashing. I took the van in to get the codes read and mechanic said it is registering a misfire on cylinder 2. I am going to replace the spark plugs and replace all ignition coil packs.. my van currently has 92k miles... spark plugs were replaced with NGKs at 60k miles. Will update soon.
I had the mechanic re-read the codes and there were two misfires in bank 2 and 5. I had the mechanic swap out all plugs with NGKs and also swapped out all the ignition coils with hitachis. I also replaced the pcv valve. The mechanic cleared all codes and drove a few miles. The van now runs very smoothly and hasn't thrown any codes/warning lights yet. I have driven it only 1 day so far about 60 miles but the warning lights normally would've turned up by now.
 
1 - 13 of 13 Posts
Top