I have read several places than when upgrading to an aftermarker subwoofer that you must disconnect the 16 pin plug from the back of your radio to disable the ANC system to prevent unwanted interference with the new sub. Problem is that after doing so, my bluetooth phone mic. doesnt appaear to be working now.
I am curious if there is a way to disable ANC without having to unplug it, since I really dont want to lose my bluetooth phone connectivity.
Using the settings with the radio, you can just turn off the noise canceling system rather than disconnecting it. In where the controls for bass, treble and balance are, just turn to the end of the list and there it is. Turn it to off.
Using the settings with the radio, you can just turn off the noise canceling system rather than disconnecting it. In where the controls for bass, treble and balance are, just turn to the end of the list and there it is. Turn it to off.
Ok latest info... ANC can be disabled by putting your radio into diagnostic mode and turning it off, BUT it only works once. As soon as you restart the car, it turns back on automatically. I did the single wire clip (white wire #4 in the harness over the front interior lights) but that didnt kill it, still got that annoying whoop whoop sound from my subs. Just unplugged the rear ANC mic (which is located just behind the rear interior lights) and it was a PITA to get to, but I got it without having to take the whole headliner out.
Will take it out for a drive a bit later and report on whether or not that finally killed it.
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Related Threads
?
?
?
?
?
Honda Crosstour Forums
34.2K posts
11K members
Since 2009
A forum community dedicated to Honda Crosstour owners and enthusiasts. Come join the discussion about performance, modifications, classifieds, troubleshooting, VSA, maintenance, and more!